Making A Better Bread Lame

This is a design which has been stuck in my head for some time now. It is made from two paint sticks. These are from the older, nicer, paint sticks which you cannot get any longer. The larger paint sticks for the large buckets of paint are still decent and will work but they are thicker overall. Walmart sells them here for .28 each and one is enough. Just cut it in half.

You Will Need:
2 paint sticks
3/16" drill bit and a Drill
2 washers
3/16 x 3/4" machine screw
3/16" Wing Nut
Wood Glue
Two clamps
scraps of wood
Miter Saw
Safety Razor Blade

One side of each stick has printing on it so you want to face the printed sides inward. Make a mark about six and a half inches from the end of the stick. From about 3" to 7" apply a very very thin coat of wood glue and clamp the sides together. Be sure and use the scrap wood to protect your Lame from marks caused by the clamps. Wipe away excess glue. Make sure your sticks are straight and even. Allow the glue to set and dry. Usually about 24 hours.

When the glue is dry, remove the clamps. Using the miter saw, cut your lame down to 6 or 6.5 inches.

On the non-glued section of the Lame decide where you will drill the hole for the machine screw. For me it was 13/16's inch from the end and and 1/2" from the edge. I put a scrap piece of wood under the Lame to minimize damage caused by the drill bit. 

Sand the Lame and finish it as desired. For mine I used a clear acrylic spray.

Bread Lame Glued

Bread Lame with Blade Installed

Bread Lame with Blade Ready to Slice

Bread Lame with Blade Ready to Slice

Bread Lame with Blade Stowed for Safety

Bread Lame Finished and Blade Stowed

Sourdough or French Bread Lame Blade Scored Dough

Sourdough or French Bread Lame Blade Scored Baked Bread

FREE 1920 x 1280 Wallpaper for Cell Phone

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 

To simplify the updating process of my blog entries I have created a single ORDER page you can go to by clicking here. As the blog slowly grows in size (a few posts each month) it becomes an arduous labor updating each and every one of them so hopefully this will make the pages easier to peruse and more enjoyable. Thank you.